ACEPOM6100 is a new intelligent instrument developed by ACEPOM technology for measuring the surface roughness of processed parts.Integrating the current microprocessor technology and sensing technology, with the advanced microprocessor and optimized highly integrated circuit design, the ultra-small architecture that ADAPTS to the current trend of instrument development is constructed, which can complete the collection, processing and display of roughness parameters.

It is applicable to processing industry, manufacturing industry, inspection, commodity inspection and other departments, especially to the large workpiece and production line on-site inspection, as well as inspection, measurement, commodity inspection and other departments.

When measuring the surface roughness of workpieces, put the sensors on the workpiece surface to be tested, by instrument internal drive mechanism drive the sensor do constant speed glide along the surface to be tested, sharp sensor through the built-in stylus feel the measured surface roughness, the workpiece is measured by the probe caused by the roughness of the surface displacement, the displacement of the sensor of the inductance coil inductance changes, thus in the output of the phase-sensitive rectifier and measured surface roughness into analog signals than columns, the signals are amplified and level after conversion into the data acquisition system, DSP chip will be data collected by digital filtering and parameter calculation,The measurement results are displayed on the LCD.

* multi-parameter measurement: ra.rz.

* high precision inductance sensor.

* built-in lithium ion rechargeable battery and charging control circuit, high capacity.

* mechatronics design, small size, light weight, easy to use.

* with automatic shutdown function.

The parameters given by this instrument conform to GB/T 3505-2000 product geometric technical specification, surface structure, contour method, description, definition and parameters of surface structure, and GB/T 6062-2002 product geometric technical specification (GPS) surface structure contour method contact (stylus) type instrument.It is applicable to processing industry, manufacturing industry, inspection, commodity inspection and other departments, especially to the large workpiece and production line on-site inspection, as well as inspection, measurement, commodity inspection and other departments.The ACEPOM6110 can be used to measure the outer circle, plane and conical surface. It can also measure the grooves with length and width greater than 80×30mm.

Parameters