Instruction:

Jingjiang ACEPOM instrument is professional in designing, producing and saling of induction bearing heaters. The SWDC series induction bearing heater, mainly sued for heating metal bearings, gears, bushings, bushing rings, pulley, etc. various types of connectors, through heating can be expanded to achieve a assembly needs. With heat sink design, better heat dissipation.

Features:

1. Automatical power regulation and demagnetization;

2. Environmental protection, no soot pollution;

3. An assembly solution with good quality, time and power saving;

4. Reliable and easy operation without fire danger.

Notes:

1. Place the yoke iron on the end face of the main engine.

2. Insert the plug into the power socket with the control switch.

3. Check whether the grounding wire is in good condition, and test with the measuring pen after the power is switched on.

4. Press the start button and the host is powered on.

5. Check that the yoke iron has no voltage to the ground.

6. Press the stop button to stop the power off and heating.

7, according to different specifications of bearings or other workpiece, choose different yoke iron cover, put the yoke iron on the top of the main machine, should be consistent with the smooth.

8. When heating, the sensor shall be inserted into the "sensor socket" and the sensor shall be attached to the heated workpiece.

9. When the bearing is heated to the required temperature, it will automatically turn off the power supply or press the stop switch.

10. After heating stops, the yoke iron moves to the left or right. Remove the bearing and put the yoke iron back to the top of the main engine.

11, if repeated use, uninterrupted heating bearing, just need to process the bearing into the yoke iron, press the start button.